Note about the throttle linkage to the govenor: The linkage needs to be "1/2 a hole short", i.e. when the throttle is
wide open, engine stopped, take the linkage out of the arm on the carb.
The gov. spring should pull the linkage 1/2 of the hole dia. past the
point where it will go in. There are no springs inside the gov. housing,
about all that can happen in there is a thrown weight or the sleeve
stuck from sitting.
from here:
http://www.smokstak.com/forum/showthread.php?t=22799
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment